When DHCP is used, you cannot specify the IPv4 address, subnet mask, or default
gateway address manually.
Default: [On]
• On
• Off
• IP Address
Specifies the machine's IPv4 address when DHCP is not used.
Use this menu to check the current IP address when DHCP is used.
Default: 192.0.0.192
• Subnet Mask
Specifies the machine's subnet mask when DHCP is not used.
Use this menu to check the current subnet mask when DHCP is used.
Default: 255.255.255.0
• Gateway Address
Specifies the machine's default gateway address when DHCP is not used.
Use this menu to check the current default gateway address when DHCP is used.
Default: 192.0.0.192
Machine IPv6 Address
You can configure the wireless LAN IP address.
• Use IPv6
Select whether to enable or disable IPv6.
Default: [On]
• On
• Off
• Link-local Address
Displays the IPv6 link local address.
• Stateless Address 0-4
Displays the IPv6 stateless addresses obtained from a Router Advertisement.
• Stateful Address
Displays the IPv6 stateful address.
• Manual Config. Add.
Specifies the machine's IPv6 address when DHCP is not used.
• IPv6 Gateway Address
7. Configuring the Machine Using the Control Panel
134
To Next Page
Loading...
