IPv4
Item Description
IPv4 Indicates that IPv4 is enabled.
Ethernet
Item Description
Host Name Enter the host name you want to set for the network interface board or wireless
LAN interface unit, using up to 63 characters. The default is RNP, followed by
the MAC address of the active interface board. If you change the name to other
than the default, the new name cannot begin with "RNP" or "rnp".
DHCP Select [Enable] to automatically configure the network settings using the DHCP
server. Select [Disable] to manually configure the network settings.
Domain Name Specify whether to use the domain name obtained from the DHCP server, or the
domain name set for the device.
• "Auto-Obtain (DHCP)" selected
When using DHCP, the domain name obtained from the DHCP server is
used. If the domain name cannot be obtained from the DHCP server, the
domain name set for the device is used.
• "Specify" selected
The domain name set for the device is used. Enter the domain name, using
up to 63 characters. Spaces cannot be used.
IPv4 Address Enter the IPv4 address of the network interface board or wireless LAN interface
unit.
At DHCP operation, the address obtained from the DHCP server is used.
Subnet Mask Enter the sub-net mask of the network interface board or wireless LAN interface
unit. The sub-net mask is a part of the IP address used as a network address.
When using DHCP, the sub-net mask obtained from the DHCP server is used.
Using Web Image Monitor
143
To Next Page
Loading...
Need help?
General
