*1 The key length, key format, and WEP key cannot be configured.
13. Enter [WEP Key / Passphrase (PSK):].
14. If it is necessary to configure the IPv4 address, click [IPv4 Configuration].
The IPv6 address can be configured only by using Web Image Monitor or control panel.
15. Click [OK].
After a setting is changed, the machine automatically restarts.
If the connection is successful, "Connection Succeeded" will be displayed.
If the connection fails, "Connection Failed" is displayed. If this is the case, try configuring the
settings again.
If [Wireless LAN Status Report:] is set to [On], a report confirming the completion of wireless LAN
setup is printed.
• When configuring [Open System - WEP], the connection appears to have been established even if
you enter the wrong WEP key and the connection fails. In this case, enter the correct WEP key.
1. Guide to the Machine
28
To Next Page
Loading...
