Riele 5010 V5+ - Working with Standard Cuvettes; Working with Discrete Flow-Through Cuvette

5010e_513.doc / 22.01.10
3.5.3 Working with standard cuvettes
The path of rays is directed from the back to the front of the device. Insert single cuvette according to the
drawing OPTIC CONSTRUCTION in TECHNICAL DATA.
Trigger setting to zero by [ZERO].
Trigger a normal measuring by [RESULT].
3.5.4 Working with discrete flow-through cuvette
For use of a discrete flow-through cuvette insert the standard cuvette adaptor.
The path of rays is directed from the back to the front of the device. Insert flow-through cuvette according
to the drawing OPTIC CONSTRUCTION in TECHNICAL DATA.
Pay attention to the correct connection of aspiration tube and outlet tube cuvette.
Switch on the pump by the function
Pump ON / OFF (chapter 7.2.4.1).
Switch on or off bubble detector by the function
Bubble detector ON / OFF (chapter 7.2.4.3).
After the installation execute a
Pump calibration (chapter 7.2.4.2).
ROBERT RIELE GmbH & Co KG Page 13 3 - OPERATING ELEMENTS