5010e_513.doc / 22.01.10
4.2 Measurement with basic methods
A photometric test can be executed by a method already permanently programmed, but open in all setting
parameters. 14 different methods with different calculation procedures are available. Each of these methods can
serve as prototype for a method programmed by the operator.
Available are:
• Absorbance measurement
• Concentration measurement / end point
measurement
• Fixed time kinetic / two point kinetic
• Kinetic
• Transmission
Scrolling through all methods is possible by
[PAGE]. The current page is shown at the
right upper screen corner. By [END] the
program returns to the main menu.
A method is selected by pressing the corre-
sponding key.
The following abbreviations are used for the
distinction of the methods:
• CONC. = concentration
• KIN = kinetic
• F = factor
• STD = standard
• RB = reagent blank
• SB = sample blank
Further information:
Chapter: 5 - CALCULATION PROCEDURES
BASIC METHODS PAGE 1/4
CONC. W. FACTOR PAGE
CONC. W. FACTOR RB
CONC. W. FACTOR SB
CONC. W. FACTOR RB SB EXIT
4.3 Method editor
Each photometric test can be permanently
stored with its setting parameters by the
method editor.
With the functions of the method editor are
possible the new installation, the change and
removing a method.
By [LIST] an overview of the programmed
methods can be printed and transmitted via
the serial interface.
Further information:
Chapter: 6 - METHOD EDITOR
METHOD NEW / CHANGE / COPY
METHOD COPY LIST
METHOD EDIT
METHOD NEW
METHOD DELETE EXIT
37.05C 09/08/09 11:39
ROBERT RIELE GmbH & Co KG Page 15 4 - PROGRAM SELECTION
To Next Page
Loading...
