Riello MULTI SENTRY Series - Page 24

MULTI SENTRY
SPTMSTD2T16EREN
22
Authorized service centers can modify all UPS configurations through configuration software (“Configurator” of
"UComGP" program) as below defined:
FUNCTION
DESCRIPTION
DEFAULT
POSSIBLE CONFIGURATIONS
BASIC
Operating mode
Selects one of five different
operating modes
ON LINE
 On Line
 Eco
 Smart Active
 Stand-By Off
 Frequency Converter
Output voltage
Selects the rated output
voltage
(Phase - Neutral)
230 V
 220 ÷ 240 1 V step
 200 V with power downgrading
 208 V with power downgrading
Output nominal
frequency
Selects the rated output
frequency
50 Hz
 50 Hz
 60 Hz
Autorestart
Waiting time for automatic
power-on after the return of
mains voltage
5 sec.
 Disabled
 Delay: 1 - 255 @1 sec step
Auto power off
Automatic UPS power-off in
battery operation mode if the
charge is lower than 5%
Disabled
 Enabled
 Disabled
Buzzer Reduced
Selects the audible alarm
operating mode
Reduced
 Normal
 Reduced: does not sound due to the
momentary intervention of the bypass
EnergyShare off
Selects the auxiliary socket
operating mode
Always
connected
 Always connected
 Disconnection after n seconds of battery
operation
 Disconnection after n seconds from the
battery low pre-alarm signal
(see software configuration manual)
Timer
Programmed UPS switching
ON-OFF
(daily)
Disabled
 Timer ON (hh:mm)
 Timer OFF (hh:mm)
FUNCTION
DESCRIPTION
DEFAULT
POSSIBLE CONFIGURATIONS
ADVANCED
Autonomy
limitation
Maximum battery operation
time
Disabled
 Disabled (complete battery discharge)
 1 - 65534 @1 sec step
Maximum load
Selects the user overload
limit
Disabled
 Disabled
 0 - 103 @1 % step
Power walk-in
start delay
Adjustable delay for the
power walk-in start up
3 sec
 Disable (0 sec set up)
 Enable 1 ÷120 @1 sec step
Power walk-in
duration
Gradual Input current ramp
absorption following mains
return
Disabled
 Disable (0 sec set up)
 Enable 1 ÷ 125 @1 sec step