RIESE & MULLER load - Wheel Change with Quick-Release

55
• Remove the left slider A diagonally to the
rear top. The tube can be replaced through
the now resulted gap.
• Alternatively you can remove the rear
wheel and remove the Harmony shifting
box (see NuVinci manual). Then it is pos
-
sible to lift the chain from the rear sprocket.
For assembly please note exactly the same
position of the shifting box.
NUVINCI AND NUVINCI HARMONY SYSTEM
Please observe the instructions of the sepa
-
rately included NuVinci manual.
CHANGING THE WHEEL ON BIKES WITH
QUICKRELEASE
Open the quick-release lever as described on
page 18.
• To facilitate the removal, draw the derail
-
leur or chain tensioner back with your hand.
Lift the bike slightly from the ground and
gently press down on the rear wheel.
WHEEL REMOVAL AT AVENUE HARMONY
Instead of removing the rear wheel it is also
possible to do the following:
• Open the quick-release of the left brake
body.
• Lift the left sidewall of the tire over the rim
and pull out the tube.
• Loosen the left axle nut.
• Loosen both bolts of the left slider dropout.
A