RIGOL
© 2008 RIGOL Technologies, Inc.
User’s Guide for DG10× 2 Series
Output from Double Channels
Output the same Sine wave from both CH1 and CH2, connect the Generator to
RIGOL’s Oscilloscope and view the waveform output.
The operation steps:
1. Use the BNC cable listed in Appendix A to connect the two [Output] connectors to
the Oscilloscope, and then press the Output buttons
2. As introduced in “Example 1: Output a Sine Wave”, set the output
parameters of the two channels as shown in the following figure.
Figure 3-13
Set the same Sine Wave
3. Press Aligpha in the above figure, adjust the Oscilloscope, using the Y-T and X-Y
(Lissajous Figure) modes to view the waveform output. See Figure 3-14 and
Figure 3-15.
Figure 3-14
Output the Same Signal
Analysis: No phase deviation, waveforms overlapping.
To Next Page
Loading...
