RIGOL
© 2008 RIGOL Technologies, Inc. 2-57
User’s Guide for DG10× 2 Series
Channel Coupling Settings
Press Utility Coupling, enter the following interface.
Figure 2-60
Channel Coupling Setting Interface
Table 2-24 Channel Coupling Setting Menu
Open or close the Coupling function
Choose CH1 or CH2 as the base source in
coupling
Set the frequency deviation between the two
channels.
Set the phase deviation between the two
channels.
Copy the parameters from CH1 to CH2
Copy the parameters from CH2 to CH1
Save the setting and exit
Key Points:
1. Channel Coupling
(1) The coupling is only used for frequency and phase, as shown in the following
figure, the base channel will mark with a “*” sign on the screen. It indicates that
CH1 has coupling in the phase parameter.
Figure 2-61
Coupling Sign Instruction
To Next Page
Loading...
