RIGOL
© 2008 RIGOL Technologies, Inc.
User’s Guide for DG10× 2 Series
Figure 2-29
To Set the voltage
Figure 2-30
To Edit the Second Point
Table 2-12 Waveform Parameter Edition Menu
Select the point to be edited
Set time for the Selected point
Set Voltage for the Selected point
Insert a new point between the defined
points. Use the “Time” and “Voltage” to
define the new point.
Save the created waveform to the
non-Volatile Memory.
Instruction:
The time for the last definable point should be less than the cycle period in the
waveform.
To Next Page
Loading...
