RIGOL
© 2008 RIGOL Technologies, Inc. 2-47
User’s Guide for DG10× 2 Series
1. English Input
The English Input Interface is shown in the following figure, to save a file named
as “NewFile”, following the steps below.
Figure 2-52
English Input Interface
(1) Press Lang EN, enter the English Interface.
(2) Input the file name “NewFile”.
Use the Knob to adjust the cursor to the right character, and press Select. Repeat
this until you have selected all the characters needed. Press +/- to choose the
majuscule or lowercase.
(3) Edit the File Name
When you have entered a wrong character, move the cursor to the wrong
character and press Remove to delete it. And then enter the file name again.
(4) Press Store to finish and save the file.
To Next Page
Loading...
