Rigol DG1012

RIGOL
© 2008 RIGOL Technologies, Inc.
User’s Guide for DG10× 2 Series
2-50
Press the Utility button, enter the following interface (two pages):
Figure 2-54
Utility Settings Interface
Table 2-22 Utility System Setting
Menu
Settings
Explanation
Sync On
Sync Off
On
Activate the Sync Signal on the [Sync Out]
Connector on the rear panel.
Off
Deactivate the Sync Signal on the [Sync Out]
Connector on the rear panel.
CH1
Basic Setting of CH1: Impedance,
Normal/Inverse display
CH2
Basic Setting of CH2: Impedance,
Normal/Inverse display
Coupling
Settings of Channel Coupling and Channel Copy
Count
Frequency Measurement in single channel.
Range: 100mHz~200MHz
Go to the next page of menus
System
Set the System Configuration
I/O
View the USB Information
Test/Cal
Test and Calibrate the instrument
Back to the previous page of menus
Save all the settings and exit