Risco LightSYS 2 Series User Manual

InstallerProgramming
Page 162
Quick Keys Parameter Default Range

Confirmation
 
TheconfirmationtimesrelatetotheZoneSequentialConfirmation
(AlarmConfirmation,see)

ConfirmStart(Confirm
delaytime)
000 1–120minutes
Specifiesthatthesystemcannotstartasequentialconfirmationprocess
untilthetimerhasexpired.Thistimestartswhenthesystemhassetand
willpreventconfirmedalarmsbeinggeneratedinsituationswhena
personhasbeenaccidentallylockedinthebuilding.

ConfirmTimeWindow
030 30–60minutes
Specifiesatimeperiodthatstartswhenanalarmistriggeredforthefirst
time.Ifasecondalarmistriggeredbeforetheendoftheconfirmation
timewindow,thesystemwillsendaconfirmedalarmtothemonitoring
station

ReportSplit  
TheReportSplitmenucontainsparametersthatenabletheroutingof
specifiedeventstouptothreeMSreceivers.

MSArm/Disarm
1
st
backup2
nd
 
ReportsArming/Disarming(meaningClosings/Openings)eventstothe
MS
Donotcall(noreport).
Send1
st
:ReportsOpeningsandClosingstoMS1.
Send2
nd
:ReportsOpeningsandClosingsto MS2.
Send3
rd
:Rep o rtsOpeningsandClosingstoMS3.
Sendall:ReportsOpeningsandClosingstothealldefinedMS.
1
st
Backup2
nd
:ReportsOpeningsandClosingstoMS1.If
communicationisnotestablished,callsMS2.
1
st
Backup2
nd
3rd:ReportstoMS1.Ifcommunicationisnot
establishedcallsMS2.Ifcommunicationisnotestablishedagaincallsthe
MS.

Risco LightSYS 2 Series Specifications

General

Control Panel Type	Hybrid
Operating Temperature	-10°C to 55°C
Outputs	4
Communication	PSTN, GSM, IP
Wireless Frequency	868MHz
Programming	Via keypad
Backup Battery	12V, 7Ah
Remote Management	Yes
Humidity	Up to 93% non-condensing