Risco LightSYS 2 Series User Manual

InstallingBusDevices
Page 43
4. Supplypowertoauxiliarydevices.RefertoWiringAuxiliaryDevices,p.29)
Note:
TheRP432EZ8enablestodefinetheend‐of‐lineresistanceofitszones.Selectionisdone
throughtheQuickkeyprogramming:.
5. MountthezoneexpanderineitheroftheLightSYS2boxleft‐slots:

Figure 3-3: Zone Expander mounting location inside the LightSYS2 box
Utility Outputs
TheLightSYS2utilityoutputssupportavarietyofdeviceactivation,basedon
periodicityorsystemevent.AsdetailedinChapter4, UsingtheInstallerProgramming
Menus
Outputs , youcanprogramcustomizeddeviceactivationpowerfullyand
granularly.
Figure 3-4: Utility Output Module UO4 (Showing an Example of UO4 Wiring)

Risco LightSYS 2 Series Specifications

General

Control Panel Type	Hybrid
Operating Temperature	-10°C to 55°C
Outputs	4
Communication	PSTN, GSM, IP
Wireless Frequency	868MHz
Programming	Via keypad
Backup Battery	12V, 7Ah
Remote Management	Yes
Humidity	Up to 93% non-condensing