Risco LightSYS 2 Series User Manual

InstallerProgramming
Page 90
Quick Keys Parameter Default Range

KeyfobInstantStay
No Yes/No
YES:Stayarmingfromany2‐wayremotecontrolwillbeinstant.
NO:Stayarmingfromany2‐wayremotecontrolwillbedelayed,
followingexitdelay1.

DisarmusingCode
No Yes/No
DefinesifaPINcodeisrequiredtoperformthedisarmoperationwhile
usinganyofthe2‐wayremotecontrols.
 Labels
TheSystemLabelsmenuenablesyoutomodifythelabelsdisplayedbytheLCDthatidentify
thesystemandpartitionlabels.Forchanginglabelsfromthekeypadrefertopage62.
System: Labels
Quick Keys Parameter Default Range

System SecuritySystem
Any16Characters
Editʹstheglobal(systemlabel)
 to

Partitions1through4
Partition1through
Partition4
Any16Characters
 Sounds
TheSoundsmenucontainsparametersthatenableyoutosetthesound(s)thatwillbe
producedafterthefollowingsystemevents.

TamperSound

Setsthesound(s)producedbyaTamperviolationofakeypadand/oran
expansionmodule,asfollows:
Silent —Producesnosound
 Bell(ExternalSiren)Only
 Buzzer(KeypadPiezo)Only
Bell + Buzzer 


Risco LightSYS 2 Series Specifications

General

Control Panel Type	Hybrid
Operating Temperature	-10°C to 55°C
Outputs	4
Communication	PSTN, GSM, IP
Wireless Frequency	868MHz
Programming	Via keypad
Backup Battery	12V, 7Ah
Remote Management	Yes
Humidity	Up to 93% non-condensing