Page viii
Table of Figures
Figure 1-1 LightSYS2 Architecture.............................................................................................10
Figure 1-2 LightSYS2-supported Keypads...............................................................................14
Figure 2-1 Box clip release...........................................................................................................23
Figure 2-2 Mounting screw template........................................................................................23
Figure 2-3 Placing the AC adapter with mains fuse..............................................................24
Figure 2-4 Placing the main panel.............................................................................................25
Figure 2-5: Main board wiring diagram....................................................................................26
Figure 2-6: Main board terminal block.....................................................................................26
Figure 2-7: Terminal block bus connectors............................................................................27
Figure 2-8: Wiring U01 for self-powered device....................................................................31
Figure 2-9: Perforated Back Tamper Release and Connection to PCB.............................32
Figure 2-10 Placing the GSM/GPRS panel and antenna.......................................................34
Figure 2-11 Placing the IP modem.............................................................................................34
Figure 2-12 Placing the Fast communication modem..........................................................35
Figure 2-13 Placing the battery and attaching the plug......................................................35
Figure 3-1: Terminal block bus connectors............................................................................39
Figure 3-2: Zone Expander board and mounting diagrams...............................................42
Figure 3-3: Zone Expander mounting location inside the LightSYS2 box......................43
Figure 3-4: Utility Output Module UO4 (Showing an Example of UO4 Wiring).............43
Figure 3-5: Utility Output Module E08......................................................................................44
Figure 3-6: Utility Output Module X-10...................................................................................44
Figure 3-7: Wireless Expander.....................................................................................................45
Figure 3-8: 1.5A PS Module..........................................................................................................46
Figure 3-9: 3A PS Module.............................................................................................................46
Figure 3-10: SMPS Inside a Metal Box.......................................................................................47
Figure 3-11: SMPS – AC & Ground Connection........................................................................49
Figure 3-12: Voice Module PCB...................................................................................................51
Figure 3-13: Voice Module — Listen/Talk Unit Wiring.........................................................52
Figure 3-14: ProSound Bus Wiring..............................................................................................53
To Next Page
Loading...
Need help?
General
