Pressing the “ ” key confirms the selection and advances to “Low Current Noise Cutoff” screen (see Section
3.2.1.9).
NOTE: Default value is set as ‘0’ mA.
This screen enables to set No. of poles of a Generator of which RPM is to be measured and to which the
instrument is connected to monitor its parameters.
3.2.1.10 No. of Poles
Pressing “ ” key accepts the present selection and advances to “Energy
Unit” menu (see Section 3.2.1.11). Similarly, pressing “ ” key accepts the
present selection and advances to “Low Current Noise Cutoff” screen (See
section 3.2.1.9).
Pressing the “ ” key advances to editing mode for no. of poles and
pressing “ ” and “ ” keys scrolls the number from 2 to 40 and 40 to 2,
respectively in steps of 2.
Pressing the “ ” key selects the status displayed and enter the “No. of Poles” menu (see Section 3.2.1.10).
NOTE: Default value is set to ‘2’.
3.2.1.11. Energy Unit
This screen enables user to set energy on modbus in terms of Wh / kWh /
MWh as per the requirement. Same is applicable to all types of energy.
Pressing “ ” key accepts the present value and advances to the “Energy
Digit Reset Count” screen (see Section 3.2.1.12).
Similarly, pressing “ ” key accepts the present value and advances to the
“No. of Poles” menu (see Section 3.2.1.10).
Pressing the “ ” key will enter the editing mode for energy unit and “ ” and “ ” keys scrolls through the
values 1,2 & 3 and in the reverse order, respectively, with roll over feature:
1 : Energy In Wh
2 : Energy in kWh
3 : Energy in MWh
Pressing the “ ” key sets the value selected and advances to “Pls Wait” screen followed by “Energy Output”
menu (see Section 3.2.1.11).
XXXX
XXXX
36
To Next Page
Loading...