3.1. Password Protection
Password protection can be enabled to prevent unauthorised access to set-up screens, when default
password protection is not enabled. Password protection is enabled by selecting a four digit number other
than 0000, setting a password of 0000 disables the password protection.
3. PROGRAMMING
The following sections comprise step by step procedures for configuring the Multifunction Meter according to
individual user requirements.To access the set-up screens press and hold “ UP ” and “ DOWN ” keys
simultaneously for 5 seconds. This will take the User into the Password Protection Entry Stage (Section 3.1).
Enter Password, prompt for first digit. .Press the “ ” key to scroll the value of
first digit from 0 through to 9, the value rolls back from 9 round to 0 and “ ”
key to scroll the value of first digit from 9 through to 0, the value rolls back from
0 round to 9.
Press the “ ” key to advance to next digit.
In special case where the Password is “0000” pressing the “ ” key when
prompted for the first digit advances to the password accepted screen and
then pressing the “ ” key again makes the set-up screens accessible to the
user.
But instead of pressing the “ ” key, if “ ” or “ ” key is pressed, the user is
taken to the “New/change Password” entry stage.
Enter Password, first digit entered, prompt for second digit..
Press the “ ” key to scroll the value of first digit from 0 through to 9, the value
rolls back from 9 round to 0 and “ ” key to scroll the value of first digit from 9
through to 0, the value rolls back from 0 round to 9.
Press the “ ” key to advance to next digit.
23
To Next Page
Loading...