Rishabh RISH LM 1340 - Server Port Setting; Quit IP Parameters

Press “ ” to enter into edit mode, prompt for first digit.
Press the “ ” and “ ” keys to scroll the value of the first digit. Press the
“ ” key to advance to next digit.
Similarly, enter second and third digits of address. After entering third digit,
pressing “ ” key confirms the selection and shows “Server Port Setting”
screen (see Section 3.2.3.4).
The default setting is ‘502’.
3.2.3.4 Server Port Settings
This screen allows the user to set Server Port for the meter.
The allowable range of addresses is 001 to 999.
Press “ ” key to advance to “Default Gateway” screen (see Section
3.2.3.3) or press the “ ” key to advance to the “Quit IP Parameters”
screen (see Section 3.2.3.5).
3.2.3.5 Quit IP Parameters
This screen allows user to exit from “ IP Communication Parameter
Selection” setup.
Pressing the “ ” key advances to “Server Port Selection” screen (see
Section 3.2.3.4). Similarly, pressing the “ ” key advances to “IP address
Selection” screen (see Section 3.2.3.1).
Pressing the “ ” key advances to “IP Parameter Selection ” screen (see
Section 3.2.3).
XXXXXXXX
XXXXXXXX
XXXXXXXX
Edit mode
43