Rishabh RISH LM 1340 - Pulse Rate; Quit Pulse Output

3.2.5.1.1.1.3 Pulse Rate
This screen applies to the Pulse Output option only. The screen allows user
to set the Energy Pulse Rate divisor. Divisor values can be selected
through 1,10,100,1000 as per Energy Unit (refer Section 3.2.1.11) set.
Refer TABLE 2.2 “Energy Pulse Rate Divisor” for details.
Pressing “ ” key accepts the present selection and takes to the “Quit
Pulse Output” menu (See section 3.2.5.1.1.1.4) and pressing “ ” key
accepts the present selection and takes to the “Pulse Duration” screen (see
Section 3.2.5.1.1.1.2).
Pressing the “ ” key advances to “Pulse Rate Divisor Edit” mode & keys
“ ” and “ ” scrolls the value through the values 1,10,100 and 1000.
Pressing the “ ” key gives the “Pulse Rate” screen (see Section
3.2.5.1.1.1.3).
The default setting is ‘1’.
Note: If energy unit/resolution is in kWh or Mwh then value is default
1.
3.2.5.1.1.1.4 Quit Pulse Output
The screen allows user to exit the Pulse Output selection menu.
Pressing “ ” key advances to the “Pulse Output” menu (see Section
3.2.5.1.1.1) and pressing “ ” key advances to the “Pulse Rate” menu
(See section 3.2.5.1.1.1.3).
Pressing “ ” key advances to the “Relay Selection” menu (see Section
3.2.5.1).
XXXXXXXX
XXXXXXXX
XXXX
Edit mode
49