Rishabh RISH LM 1340 - Relay Configuration; Limit Output on Delay

3.2.5.1.1.2.8 Limit Output ON Delay
This screen allows the user to set ON Delay time in seconds for Relay
Limit Assigned Parameter.
Pressing “ ” key accepts the present value and advance to “Limit Output
OFF Delay” screen (see Section 3.2.5.1.1.2.9) and pressing “ ” key
accepts the present value and advances to “Relay Configuration” screen
(see Section 3.2.5.1.1.2.7).
This screen is used to select one of the two configurations of relay for the
selected limit output parameter. (see Section 3.2.5.1.1.2.1)
Pressing the “ ” key accepts the present selection and advances to the
“ON Delay” screen (see section 3.2.5.1.1.2.8) and pressing the “ ” key
accepts the present selection and advances to the “Logic Operation”
screen (see section 3.2.5.1.1.2.6).
3.2.5.1.1.2.7 Relay Configuration
XXXXXXXX
XXXXXXXX
Pressing the “ ” key advances to Relay Configuration edit mode and “ ”
and “ ” keys scrolls through the modes available.
EnrG (To Energize Relay)
d-Enr (To De-Energize Relay)
Note: Default configuration is set to ‘EnrG’.
(For details refer to section 5.2)
Pressing the “ ” key sets the selected config. and advances to “Relay Configuration” menu screen (See
section 3.2.5.1.1.2.7).
XXXXXXXX
Relay Configuration Edit Mode
54