Installation & Operating Instructions
DIGITAL MULTIFUNCTION INSTRUMENT
Section Contents
1. Introduction
2. Measurement and Energy/Counter Screens
2.1 Current Reversal Screen
Phase Rotation Error Screen 2.2
2.3 Phase Absent Screen
2.4 Individual Harmonics
2.5 Load Health Monitor Screen
2.5.1 Load Health Monitor Fault Screens
2.6 Pre-Paid Energy Menu
2.7 Timer 1 & Timer 2 Screens
2.8 Run Hour
2.9 Hour On
2.10 Interruption Number of
3. Programming
3.1 Password Protection
3.2 Menu Selection
3.2.1 System Parameter Selection
3.2.1.1 System Type
3.2.1.2 Potential Transformer Primary Value
3.2.1.3 Potential Transformer Secondary Value
3.2.1.4 Current Transformer Primary Value
3.2.1.5 Current Transformer Secondary Value
3.2.1.6 System Frequency
3.2.1.7 Demand Integration Time
3.2.1.8 Auto Scrolling
3.2.1.9 Low Current Noise Cutoff
3.2.1.10 No. of Poles
3.2.1.11 Energy Output
3.2.1.12 Energy Digit Reset Count
3.2.1.13 Energy Rate
3.2.1.14 Impulse Rate
3.2.1.15 Version Information
3.2.1.16 Quit System Parameters
DMAN-00IM-0922 Rev.B - 04/2022
1
To Next Page
Loading...