Rishabh RISH LM 1340 - Output Option Configuration

To Next Page

To Previous Page

3.2.5.1.1 Relay 1 or 2 Output Selection Menu

3.2.5.1.1.0 None Output

Pressing “ ” key makes the following options available for relay1 and

relay2:

0. None : No Parameter selected for Relay output (see Section 3.2.5.1.1.0)

1. Pulse : Relay in Pulse output mode (see Section 3.2.5.1.1.1)

2. Limit : Relay in Limit output mode (see Section 3.2.5.1.1.2)

3. Timer : Relay in Timer output mode (see Section 3.2.5.1.1.3)

4. Load Health : Relay in Load Health mode (see Section 3.2.5.1.1.4)

5. Pre Paid Energy : Relay in Pre Paid Energy mode

(see Section 3.2.5.1.1.5)

This screen indicates that no parameter is selected for Relay 1

Pressing “ ” or “ ” key takes the user back to “Relay Selection” screen

(see Section 3.2.5.1).

3.2.5.1 Relay Selection

Pressing “ ” and “ ” keys scrolls through the following screens:

rEL1 : To select options for relay 1 (See section 3.2.5.1.1).

rEL2 : To select options for relay 2 (See section 3.2.5.1.1).

quit : To exit the Output Options menu and give the “Output Option

Selection” screen (see Section 3.2.5).

Pressing “ ” key advances to Relay1 or 2 Output Selection menu (see

Section 3.2.5.1.1).

3.2.5. Output Option Selection

This screen applies to the relay output option selection. Pressing “ ” key advances to “Relay Selection”

menu (see Section 3.2.5.1).

XXXXXXXX

Press “ ” and “ ” keys to navigate between the above options and press “ ” key to confirm the selection.

NOTE : The default option is set as ‘None’.

XXXXXXXX