Rishabh RISH LM 1340 - Pulse Output

3.2.5.1.1.1 Pulse Output
This screen is used to set the pulse output parameter.
Pressing “ ” key advances to “Parameter Selection” screen (see Section
3.2.5.1.1.1.1) whereas pressing “ ” key advances to “Quit Pulse Output”
menu (see Section 3.2.5.1.1.1.4).
XXXXXXXX
3.2.5.1.1.2 Limit Output
This screen is used to assign Relay in Limit output mode.
Pressing “ ” key shows “Parameter Selection” screen (see Section
3.2.5.1.1.2.1) whereas pressing “ ” key shows the “Quit Limit Output”
screen (see Section 3.2.5.1.1.2.10).
3.2.5.1.1.3 Timer Output
This screen is used to assign Relay in Timer output mode.
Pressing “ ” key will give the Number of Cycles menu (see Section
3.2.5.1.1.3.1) whereas pressing “ ” key gives the Quit Timer output menu
(see Section 3.2.5.1.1.3.5).
XXXXXXXX
XXXXXXXX
46