Rishabh RISH LM 1340 - Parameter Selection; Pulse Duration

To Next Page

To Previous Page

3.2.5.1.1.1.1 Parameter Selection

This screen allows the user to assign energy for pulse output.

Pressing “ ” key accepts the present setting and advance to “Pulse

duration selection” (see section 3.2.5.1.1.1.2) and pressing “ ” key

accepts the present setting and advance to “Quit Relay Output” selection

(see section 3.2.5.1.1.1.4).

Pressing the “ ” key advances to edit mode and “ ” and “ ” keys

scrolls through the values, as per TABLE 2.1, “parameters for pulse

output”.

Pressing the “ ” key sets the value & gives the “Parameter Selection”

menu (see section 3.2.5.1.1.1.1).

NOTE: Default configuration is set as ‘0’, i.e., System Wh Import.

3.2.5.1.1.1.2 Pulse Duration

This screen applies only to the Pulse output mode of relay. This screen

allows the user to set Relay energization time in milliseconds.

Pressing “ ” key accepts the present value and advance to “Pulse Rate”

screen ( see section 3.2.5.1.1.1.3). Similarly, pressing “ ” key accepts the

present value and advance to “Parameter Selection” screen ( see section

3.2.5.1.1.1.1).

Pressing the “ ” key advances to “Pulse Duration Edit” mode and “ ”

and “ ” keys scroll the value through 60, 100 and 200 ms.

Pressing the “ ” key selects the value and advances to “Pulse Duration ” menu (see Section 3.2.5.1.1.1.2).

NOTE: Default value is set to ‘100’ ms.

Edit mode

XXXXXXXX