Rishabh RISH LM 1340 - Quit Limit Output; Number of Cycles

3.2.5.1.1.2.10 Quit Limit Output
The screen allows user to exit the Relay output selection menu.
Pressing “ ” key advances to “Limit Output” menu (See section
3.2.5.1.1.2) and pressing “ ” key advances to “Limit Output OFF Delay”
menu (see Section 3.2.5.1.1.2.9).
Pressing “ ” key advances to “Relay Selection” menu (see Section
3.2.5.1).
3.2.5.1.1.3.1 Number of Cycles
The value decides how many times the timer will repeat the switching after
it has been started in the timer based relay output option.
Pressing “ ” key confirms the value and advances to the “Timer
Configuration” menu (See section 3.2.5.1.1.3.2) and pressing “ ” key
advances to “Timer” menu (See section 3.2.5.1.1.3).
The value for this parameter can range from 0000 to 9999.
If the value is set as 0000, the timer will keep repeating the cycles until
9999 cycles are complete or the timer is stopped by the user.
Refer Section 5.3 for more details.
Press “ ” key, prompt for the first digit.
Press the “ ” and “ ” keys to scroll the values of the first digit.
Press the “ ” key to advance to next digit.
Similarly, enter second, third and fourth digits also.
After the fourth digit has been entered, pressing “ ” key sets the value
and advances to “Number of Cycles” screen (see Section 3.2.5.1.1.3.1).
The default setting is ‘10’ cycles.
XXXX
XXXXXXXX
XXXXXXXX
56