Rishabh RISH LM 1340 - Communication Parameter Selection

3.2.2 Communication Parameter Selection
3.2.3 IP Parameter Selection
This screen is used to select the different communication parameters like
“Address selection”,“RS485 Parity selection”, “RS485 baud rate”, etc.
Pressing the “ ” key allows the user to set different Communication
parameters (see Section 3.2.2.1 to 3.2.2.3).
Pressing the “ ” key advances to the “Reset Parameter Selection” screen
(if ethernet module is present then it will advance to IP parameter selection
see section 3.2.3) (see section 3.2.4) and pressing “ ” key advances to
the “System Parameter Selection” screen (see Section 3.2.1).
This screen is used to select the different communication parameters like
“IP Address selection”,“Subnet mask selection”, “default gateway
selection”,server port selection etc.
Pressing the “ ” key allows the user to set different Ethernet parameters
(see Section 3.2.3.1 to 3.2.3.4).
Pressing the “ ” key advances to the “Reset Parameter Selection”
screen (see section 3.2.4) and pressing “ ” key advances to the
“Communication Parameter Selection” screen (see Section 3.2.2).
3.2.4 Reset Parameter Selection
This screen is used to reset different parameters.
Pressing the “ ” key allows the user to reset different parameters (see
Section 3.2.4.1).
Pressing the “ ” key advances to the “Output Option Selection” screen
(see Section 3.2.5) and pressing “ ” key advances to “Communication
Parameter Selection” screen (see Section 3.2.2) (If ethernet module is
present then it advances to IP parameter selection (see Section 3.2.3) else
it goes to serial communication parameter selection) .
27