Rishabh RISH LM 1340 - RS 485 Baud Rate; RS 485 Parity; Quit Communication Parameters

3.2.2.2 RS 485 Baud Rate
This screen allows the user to set Baud Rate of RS 485 port. The values
displayed on screen are in kbaud.
Pressing “ ” key accepts the present value and advance to the “RS 485
Parity Selection” screen (see Section 3.2.2.3) and pressing the “ ” key
accepts the present value and advance to the “Address Setting” screen
(see Section 3.2.2.1).
Pressing the “ ” key advances to the “Baud Rate Edit” mode and “ ” &
“ ” keys scrolls the value through 4.8, 9.6, 19.2, 38.4 and 57.6 kbaud.
3.2.2.3 RS 485 Parity
This screen allows the user to set Parity & number of stop bits of RS 485 port.
3.2.2.4 Quit Communication Parameters
Pressing the “ ” key sets the value and shows the “RS 485 Baud Rate” screen (see Section 3.2.2.2).
NOTE: Default value is set as ‘9.6’.
Pressing “ ” key accepts the present value and advances to “Quit
Communication Parameters” screen (see section 3.2.2.4).Similarly,
pressing “ ” key accepts the present value and advances to “RS 485
Baud Rate” screen (see section 3.2.2.2).
Pressing the “ ” key advances to the “Parity & Stop bit Edit” mode &
keys “ ” and “ ” scrolls the value through:
nonE1 : no parity with one stop bit nonE2 : no parity with two stop bit
EVEn : even parity with one stop bit odd : odd parity with one stop bit
Pressing “ ” key sets the value and advances to “RS 485 Parity Selection” screen (see Section 3.2.2.3).
NOTE: Default value is set as ‘nonE1’.
This screen allows user to exit from system “Communication
Parameter Selection” setup.
Pressing the “ ” key advances to “Address Setting” screen (see Section
3.2.2.1). Similarly, pressing the “ ” key advances to “RS 485 Parity”
screen (see Section 3.2.2.3).
Pressing the “ ” key advances to “Communication Parameter Selection ”
screen (see Section 3.2.2).
XXXX
XXXX
XXXX
40