Rishabh RISH LM 1340 - Page 4

3.2.2 Communication Parameter Selection
3.2.2.1 Address Setting
3.2.2.2 RS 485 Baud Rate
3.2.2.3 RS 485 Parity
3.2.2.4 Quit Communication Parameters
3.2.3 IP Parameter Selection
3.2.3.1 IP Address Setting
3.2.3.2 Subnet mask Setting
3.2.3.3 Default gateway Setting
3.2.3.4 Server Port Setting
3.2.3.5 Quit IP Parameters
3.2.4 Reset Parameter Selection
3.2.4.1 Resetting Parameter
3.2.5 Output Option Selection
3.2.5.1 Relay Selection
3.2.5.1.1 Relay 1 or 2 Output Selection Menu
3.2.5.1.1.0 None Ouput
3.2.5.1.1.1 Pulse Output
3.2.5.1.1.1.1 Parameter Selection
3.2.5.1.1.1.2 Pulse Duration
3.2.5.1.1.1.3 Pulse Rate
3.2.5.1.1.1.4 Quit Pulse Output
3.2.5.1.1.2 Limit Output
3.2.5.1.1.2.1 Limit Output Parameters
3.2.5.1.1.2.2 Alarm Configuration
3.2.5.1.1.2.3 Trip Point
3.2.5.1.1.2.4 Hysterisis
3.2.5.1.1.2.5 Energy Trip Point
3.2.5.1.1.2.6 Logic Operation Selection
3.2.5.1.1.2.7 Relay Configuration
3.2.5.1.1.2.8 Limit Output ON Delay
3.2.5.1.1.2.9 Limit Output OFF Delay
3.2.5.1.1.2.10 Quit Limit Output
3.2.5.1.1.3 Timer
3.2.5.1.1.3.1 Number of Cycles
3.2.5.1.1.3.2 Timer Configuration
3.2.5.1.1.3.3 On Delay
3.2.5.1.1.3.4 Off Delay
2