8 - PROPULSION SYSTEM237
8.5 STOP OF PROPULSION ENGINES
Do not immediately stop the engines after a full-load operation, but let them
run low (about 5 minutes) to balance the temperature differences.
From inner helm station
• Recall levers (1) and (2) to the middle neutral position of the inverter.
• Press the “STOP” button (3) and (4).
• Turn the keys (5) and (6) to the OFF position.
• Disconnect the magneto-thermal switches for the starter keys of the two
engines.
CAUTION
With engines stopped carry out following:
• Disconnect all unnecessary electric uses and check the general status
of the switchboard as well as the voltmeters and ammeters indications;
• Check the switches of the bilge pumps and their regular operation;
• Check for possible leaks from the shaft lines seals;
• Rinse the yacht with fresh water;
• Connect the shore electric power supply;
• Keep the engine room extractor running for about 30 minutes, for ven-
tilation and air cooling.
1
2
3 4
5 6
To Next Page
Loading...