12 - INFORMATION FOR USE369
Lower the handwheel lever into its seat.
To enable water inlet from SEA, proceed
as described above, turning the hand-
wheel counterclockwise.
Once the operation is nished the word-
ing in the handwheel window will read:
APERTO MARE / SEA OPEN which in-
dicates the inlet position.
12.14.2 Maintenance
During ordinary maintenance, which must be carried out while the yacht is
in dry shore, it is recommended to extract the valve control block as follows:
make sure that the indicator is positioned to SEA OPEN (rst turn the hand-
wheel counterclockwise).
Loosen the screws with an Allen wrench and extract the mechanism from its
body, paying special attention to the rubber components (gaskets).
DO NOT remove the handwheel from its seat!
If necessary, clean the rubber components with fresh water and soap, do
not use any chemical cleaners and pay attention not to damage the gaskets.
If necessary, the control block can be replaced with a new one.
When reassembling, use silicone grease, and pay special attention to the
seats of the gaskets.
Make sure to insert the mechanism in “APERTO MARE - SEA OPEN” posi-
tion (rst turn the handwheel counterclockwise as indicated in the INSTRUC-
TIONS).
Tighten the screws with a torque of approx. 9 Nm.
To Next Page
Loading...