Riva 90 ARGO - Page 352

12 - INFORMATION FOR USE 346
12.7 REFUELLING
• Ensure the yacht is properly moored, stop engines and generators if
running.
• The fuel ller is located into the suitable peak on each lateral walk around
of the yacht.
• Wash the teak with fresh water ahead of time to prevent soiling it ac-
cidentally.
• Loosen the lling nozzle, make sure that the refuelling pump is the cor-
rect size, then insert the pump and hold it still.
• Do not top up the tanks to the highest level, so as to allow the fuel to
expand into the tank, without spilling out from vents.
• Tighten the ller cap rmly and remove any fuel drop from the hull and
the teak.
CAUTION
The inlet plug carries the indication “DIESEL” to avoid accidental input of
different fuels.
Filling lines pressure must be kept constantly under 0.3bar during bunker-
ing operations.
CAUTION
When refuelling open the llers on both sides of the yacht.