EasyManua.ls Logo

Riva 90 ARGO - Page 384

Riva 90 ARGO
436 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13 - HULL AND FURNITURE MAINTENANCE 378
13.1 GENERAL MAINTENANCE OUTLINES
The yacht is equipped with large number sophisticated devices and sys-
tems, which require not only a certain care when it comes to use, but also
regular maintenance to obtain correct operation.
One of the factors that might cause problems or faults, is usually the irregu-
lar use of the yacht and because of this, of the on-board devices.
Experience indicates that regular use of the devices normally gives fewer
problems, and therefore, we recommend operating all on-board devices
regularly, for short periods.
Daily checks and regular maintenance are important for maintaining equip-
ment/components in the best working order and efciency. If the regular
maintenance schedule is not correctly followed, the equipment’s perfor-
mance can deteriorate, causing reduced efciency, a shorter life and the
occurrence of unexpected problems which can compromise safety at sea.
The maintenance schedule is based on time intervals or running hours.
For example, if a maintenance task is scheduled every 100 hours or 3
months, this task must be repeated at 200 hours or after 6 months, at 300
hours or after 9 months, and so on.
In case of a long period of inactivity (for example during winter) it is advis-
able to lay up the yacht, possibly under cover.
CAUTION
Some general information about ordinary maintenance tasks, their sched-
ule and procedures is provided herein.
For further specic information referring to the maintenance schedule,
see the Manufacturer Manuals for on-board devices/components, issued
by the various Manufacturers.
CAUTION
Check periodically that all equipment containing water is lled with the
correct amount of anti-freeze.
If the outside temperature drops below 0°C, all fresh or sea water sys-
tems, are exposed to the risk of freezing and consequent breakage.
Systems especially subject to risks of freezing are both the sea water sys-
tems (for instance engine cooling system, generator cooling system), and
the fresh water systems (for instance: the windscreen washer system, the
fresh water pump, etc..), that is: all systems and devices containing either
fresh or sea water.

Table of Contents