3 - SAFETY DEVICES AND EQUIPMENT 60
3.4.5 Fire-ghtingsystemintheengineroom
Checks and tests
To make sure that the re extinguisher is operational, the pressure gauge
must be in the green eld.
CAUTION
Accidental discharge during handling or installation may cause serious
injury. Re-insert the safety pin tted by the Manufacturer on the sensing/
detecting valve of the cylinder up to complete and controlled installation.
Protect eyes during the installation or maintenance.
WARNING
During maintenance operations, pay attention not to break the ask lo-
cated on the cylinder, because, even if the safety pin is inserted, if the
ask breaks, the re-ghting system activates.
MAINTENANCE
At least once a month, and in any case, before each navigation, check the
charge status of the re extinguisher.
At least once a month, and in any case, before each navigation, check the
external condition of the re extinguisher. At least every 6 months check
the fastening of the re extinguisher.
3.4.6 Fire hoses
On board there are many re hoses that allow the re extinguisher.
To put under pressure the re hose system, push the button at bow.
NOTE
When the button is pressed, is also activated the chain washer.
To Next Page
Loading...