TRS 1⁄4-inch cable – this allows you to control two functions on an amp with each switching jack, providing access to
all four function switches. This connection is typically used with amps that have two button footswitches.
Insert cable – an insert cable is a 1⁄4-inch cable that has a TRS (aka stereo) connector on one side and two 1/4-inch
mono connectors on the other end. Insert cables allow you to access both function switches on a jack, but split them to
two different switching jacks on the amp. This connection is typically used with amps that have a non-standard
footswitch jack and more than one 1/4-inch external switching jacks. (Mesa Boogies are good examples of this). Please
note! Don’t connect the two mono plugs of an insert cable to two different amps or other devices – this can cause a
ground loop or worse electrical problems.
The two function switch jacks are electrically isolated from each other, so it is safe to connect each jack to a different
amp. Just don’t try splitting one jack to two different amps!
The default settings for each switch are latching and normal (non-inverted). These settings will work with the majority
of amps. If your amp has different requirements, you can use the Fn Switch Settings section of the setup menu to
change the settings for each switch.
To Next Page
Loading...
Need help?
General
