Dry – This button controls the dry signal that is sent to the line mixer. Please refer to the Function Switches section for
more information.
Buf 1 – Buf 3 – These buttons control the three internal audio buffers. Please refer to the Audio and Switching features
section for more details.
In this mode, holding the Loops button for 3 seconds will store the current switch configuration to the currently
selected preset. The next time the preset is selected, the stored configuration for each of the above switches will
automatically be recalled.
Pressing the Loops button will return you to preset mode.
Programming a Preset
To summarize the previous sections, this is how you program a preset:
1. First, select the desired preset using the bank and preset buttons.
2. Press the Loops button to enter loop selection mode.
3. Use the L1 through L10 buttons to turn on the desired loops for this preset.
4. Hold the Loops button for 3 seconds to store.
5. Press the Loops button to return to preset mode.
6. If you don’t need to adjust function switches, buffers, dry send or outputs, you’re done with this preset!
Otherwise, continue with the next steps:
7. Press the Switches button enter switch selection mode.
8. Use the buttons to turn on the desired switches as described in the section above.
9. Hold the Loops button for 3 seconds to store.
10. Press the Loops button to return to preset mode.
You can repeat this for each of the Mastermind PBC’s 768 presets.
To Next Page
Loading...
Need help?
General
