Name - Allows you to name the expression pedal.
SndOnPrst – Turning this on makes the expression pedal send its current CC value(s) every time you change to a new
preset. This parameter is only available in the global expression pedal menu.
Calibrate – Enters pedal calibration. You are asked to move the pedal all the way up and all the way down. This insures
that the pedal will work optimally with the Mastermind PBC. Press the Done soft button when you are finished. This
parameter is only available when editing the global pedal parameters from the Main Menu.
Device – Selects the device this pedal will control. Uses the Device Select Menu to allow you to choose from the
defined devices.
CC Number – Allows you to edit the continuous controller number sent by the pedal.
Min Val – Sets the value sent by the expression pedal when the pedal is raised up all the way.
Max Val – Sets the value sent by the expression pedal when the pedal is pushed all the way down.
Assign CC – This button allows you to choose a continuous controller from the list of functions defined for each device.
When this button is selected, you are prompted for one of the functions available on the device. The continuous
controller number associated with that function is to the CC Number parameter, and default values are filled in for Min
Val and Max Val.
Device 2, CC Number 2, Min Val 2, Max Val 2 and Assign CC 2 – These parameters allow you to set up the expression
pedal to control a second CC parameter at the same time as it controls the first CC. This is particularly useful for cross-
fading, where one parameter decreases while the another parameter increases (and vice-versa).
Set Switch – Sets the expression pedal’s switch point to the current pedal position. Please refer to the Expression Pedal
section for more details.
Switch Invert – Inverts the sense of the expression pedal position switch. Please refer to the Expression Pedal section
for more details.
To Next Page
Loading...
Need help?
General
