1: Getting Started
Fitting the Coach Bolt
Note:-
The maximum thickness of the desk is 60mm.
Toolbox:- Pozidriv no. 1 screwdriver, adjustable spanner and drill with
18mm drill bit
1. Remove the cover (see page 29).
2. Locate the hole in the centre of the base of the chassis. Position
the computer then mark the desk or tabletop using a pencil.
Note:
Remember to allow room at the back of the computer for the cables
and re-fitting the lid when deciding on a suitable position.
3. Drill an 18mm hole in the required position in the desk or
tabletop.
4. Position the RM One over the hole and push the bolt through the
base of the RM One and into the desk
5. Underneath the desk, secure with the supplied padlock
6. Replace the cover (see page 29).
Padlock and keys
For ease of management of a number of PCs, RM supply padlocks
with common keys. This enables you to use the key from any RM PC
to remove the padlock.
Note:
Ensure you keep all keys in a safe place, as one lost key can be used
to open any number of PCs.
Access
To restrict access to the computer, place it in a room where you can
control who uses it. If the computer is being used as a server on a
network then locking the computer in a separate room is a practical
solution as long as there is adequate ventilation.
11
To Next Page
Loading...
