5: Technical Information
Make sure that no liquid seeps into any of the equipment especially
the inside of the computer or keyboard, so keep food and liquids
away. Avoid using aerosols or strong cleaning agents.
Do not use a damp cloth to clean floppy disks.
Do not attempt to clean the interior of the computer. This service
should only be performed by a fully qualified RM technician.
Moving and Re-packing the Computer
If you need to move your computer a short distance - to an adjoining
room for example - disconnect all equipment connected to the
computer.
1. Ensure that the floppy disk drive LED is off and remove any floppy
disks from the floppy disk drive(s).
2. Back up important or unsaved work and close down the operating
system. Check that the hard disk drive LED is off.
3. Switch off your computer, the monitor and any other equipment
attached to it.
4. Disconnect any equipment from your computer and disconnect the
computer from the mains.
5. Prepare the new surface to put your computer on. It should be
flat, firm and dry.
6. Carefully lift your computer and put it down gently at its new
location.
7. Reconnect your system as shown on the Quick Start Guide.
Remember, if you move your computer from a cold room to a warm
one, allow the computer to warm to room temperature before
switching it on.
42
To Next Page
Loading...
