6.2.5 Testing the drive pedal neutral position
With this test you will test the functioning of the drive pedal safety mechanism.
1. Park the machine safely.
2. Sit on seat.
3. Operate the foot pedal.
4. Attempt to start the engine.
The engine should not start. If the engine does start, there is a problem with the safety circuit. Contact your Roberine
dealer for repair.
6.2.6 Testing the parking brake (2)
With this test you will test the functioning of the parking brake in general.
1. Start the engine.
2. Place the machine up hill on an incline of 26 % (15°)
3. Apply the parking brake.
4. Stop the engine.
The parking brake must ensure that the machine remains stationary. If the machine does not remain stationary, there
is a problem with the safety circuit. Contact your Roberine dealer for repair.
6.3 Daily checks before use
Before every use, make sure that:
• all protective screens and covers have been fitted.
• there are no loose, missing or damaged parts.
• the safety systems have been tested as described in Testing the safety system on page 26.
• the indicators work.
• the engine oil level is correct and add oil if necessary.
• the hydraulic oil level is correct and add oil if necessary.
• there are no hydraulic oil leaks.
• the coolant level is correct and add fluid if necessary.
• the fuel level is sufficient.
• the tyres show no sign of damage and the tyre pressure is correct.
• the wheel bolts are properly tightened.
• the red plunger of the air resistance indicator is not visible.
• there is no dirt on the air intake grill, the radiator and the engine compartment.
• there is no water in the fuel/water separator.
• the rear axle and the rollers and bearings of all mowing units have been lubricated.
Commissioning 28
To Next Page
Loading...
