Roberine F3 - Every 1,000 Hours; Every 1,500 Hours or Every 2 Years; Every 2,000 Hours or Every 2 Years; Every 3,000 Hours or Every 3 Years

8.3.7 Every 1,000 hours
Material Maintenance type
Valve clearance Contact your Roberine dealer.
Intake and exhaust cylinder head valve clearance Contact your Roberine.
8.3.8 Every 1,500 hours or every 2 years
Material Maintenance type
Fuel injectors Contact your Roberine dealer.
Battery terminals Clean.
8.3.9 Every 2,000 hours or every 2 years
Material Maintenance type
Coolant Replace.
Thermostat Replace.
8.3.10 Every 3,000 hours or every 3 years
Material Maintenance type
Diesel injection pump Inspect. See the technical instruction manual, or contact
your Roberine dealer.
8.4 Lubrication
8.4.1 Lubricants
Roberine recommends the following types of lubricants:
Mowing units Connections between the hydraulic motor and the
rotor clutch
Polyurea – NLGI-class 0
Calcium Complex – NLGI class 0
Do not combine
Do not mix other types of lubricants (including lubricants with a calcium, lithium and lithium 12-hydroxyl base) with the
lubricants recommended above; they cannot be combined. For the best result, fully remove the lubricants that cannot be
combined from the housing and apply a lubricant recommended above. Do not use biolubricants.
Weather conditions
The types of lubricants recommended by Roberine are suitable for an average temperature of between -29 °C and 135
°C. When using the machine in a temperature outside of this range, please contact your maintenance dealer for special
types of lubricants. Lubricants that meet military specification MIL-G-10924F can be used in extremely cold conditions.
Maintenance 40