Roberine F3 - After the First 5 Hours; Daily Maintenance; After the First 50 Hours

• Extreme heat, excessive dust or other extreme conditions may cause engine parts to become dirty or
blocked.
• The quality of the engine oil may be reduced if the machine is constantly driven too slow or at a low engine
speed, or if it is intensively used for short periods of time.
8.3.1 After the first 5 hours
Material Maintenance type
Tyres Inspect for damage and wear, replace if necessary.
Tyre pressure Check if they are at the correct pressure
Mounting materials Inspect and adjust if necessary.
Hoses Inspect for damage and wear, repair or replace if
necessary.
Drive wheel bolts Inspect and adjust if necessary.
Parking brake Check its functioning.
Hydraulic system Check for oil leaks
8.3.2 Daily maintenance
Material Maintenance type
Engine air filter Clean.
Cabin air filter Clean.
Cooler Clean.
AC cooler on cabin roof Clean.
Engine coolant Check and refill. See Cooling system on page 45.
Lubrication points See Lubrication on page 40.
8.3.3 After the first 50 hours
Material Maintenance type
Air intake and coolant hose clips Inspect and replace if necessary.
Fuel/water separator Inspect and drain if necessary.
Engine oil & oil filter Replace.
Hydraulic filters Replace.
Fan belt Check the tension.
Fan belt Inspect for damage and wear and replace if necessary.
Maintenance 38