Roberine F3 - Every 50 Hours; Every 250 Hours; Every 500 Hours or Once a Year

8.3.4 Every 50 hours
Material Maintenance type
Lubrication points Lubricate (see also Lubrication on page 40).
Parking brake switch Check its functioning.
Battery Inspect.
Hoses Inspect for damage and wear, repair or replace if
necessary.
Hydraulic system Check for oil leaks
Sealing surfaces from the bonnet to the cooler Inspect for damage and wear, adjust if necessary.
Drive wheel bolts Inspect and adjust if necessary.
ROPS Inspect the system for damage and wear. Maintenance
may only be done by you Roberine dealer.
Mowing units Inspect the mounting materials and adjust if necessary
Bonnet Clean under the bonnet and check lock.
Flails Check for wear and damage.
8.3.5 Every 250 hours
Material Maintenance type
Engine oil & oil filter Replace.
V-belt Inspect for damage and wear.
V-belt Check the tension
Air intake hoses, hydraulic lines and hoses, radiator hoses
and hose clips
Inspect for damage and wear, replace if necessary.
Radiator fins Check and clean. See Cleaning the air intake grill and
engine cooler on page 44.
8.3.6 Every 500 hours or once a year
Material Maintenance type
Hydraulic oil & filters Replace.
Coolant Inspect clarity and the freezing point, replace if necessary.
Fuel filter Replace. See Fuel filter and fuel/water separator on page
46 .
Engine oil and filters Replace. See Changing the engine oil and filter on page
43
1
.
Battery terminals Inspect.
1. May differ depending on the application or engine oil capacity. If the engine is equipped with a shallow oil sump, the
maintenance interval should be every 250 hours.
Maintenance 39