Roberine F3 - Replacing the Battery; Cleaning the Battery Terminals; Replacing the Light Bulbs

Before you begin: Make sure that the battery is clean, the battery bolts are tightened and the ventilation holes aren't
blocked.
1. Check the battery indicator (1):
• Green: battery in good working order.
• Black: battery must be charged.
• White: battery must be replaced.
2. If necessary, charge the battery for 1
hour with 6-10 A.
8.16.1.2 Replacing the battery
When replacing the battery, always replace it with one specified by Roberine. Contact your Roberine dealer.
Before you begin: Park the machine safely and let the engine cool down.
1. Disconnect the negative (-) battery cable.
2. Push the red cover away from the positive (+) terminal and disconnect the battery cable.
3. Disconnect the battery holder.
4. Remove the battery.
5. Place the new battery on the battery tray.
6. First connect the positive (+) cable to the positive (+) battery terminal and then the negative (-) cable to the negative
(-) battery terminal.
7. Apply acid-free spray lubricant on the battery terminals to prevent corrosion.
8. Slide red cover over the positive battery terminal.
9. Install the battery holder.
8.16.1.3 Cleaning the battery terminals
Before you begin: Park the machine safely and let the engine cool down.
1. Disconnect the battery (see Replacing the battery on page 56).
2. Clean the terminals and the battery cable ends with a wire brush until they are bright.
3. Reconnect the battery (see Replacing the battery on page 56).
4. Apply acid-free spray lubricant on the terminals to prevent corrosion.
8.16.2 Replacing the light bulbs
Replace the light bulbs immediately when they are broken.
CAUTION!
Maintenance 56