9
Step 2 - Plug in your speaker and switch on for fi rst use
1. Place your speaker on a fl at surface and plug the cable from the mains
adaptor into the DC input socket located on the rear of the speaker (marked
'DC In') ensuring that the plug is pushed fully into the socket.
2. If you wish to use a wired network connection, plug the Ethernet cable into
the RJ-45 socket at the back of the speaker.
3. Ensure that the Stereo mode switch is in the 'Normal' or 'Wide' position.
4. Plug the mains adaptor into a wall socket and switch on the socket.
IMPORTANT: The mains adaptor is used as the means of connecting the
speaker to the mains supply. The mains socket used for the speaker must
remain accessible during normal use. In order to disconnect the speaker
from the mains, the mains adaptor should be removed from the mains socket
outlet completely.
5. Press and release the Power button. The Power indicator will glow white.
6. After approximately 10 seconds the Mode indicator will fl ash slowly (white).
7. Your speaker is now ready to be connected to your home network.
• After each use the speaker will remember the mode used and then switch
on in that mode the next time it is used.
Note: If your speaker has not previously been connected to a network,
the Mode indicator will fl ash white. If this is not the case please reset the
speaker see page 36.
8. Use the UNDOK app to connect your speaker to your network. If adding
more than one product this must be done for the fi rst time each product is
used.
Mode indicator white
Power/Standby indicator
(white)
Power
1
Speaker ready to connect
(fl ashes slowly)
To Next Page
Loading...
