11
Note: If when setting up your speaker your Android device complains that it cannot connect to the internet
this is because it is temporarily connected directly to your speaker. You should ignore this warning message.
1. Open the UNDOK
app.
2. Setup a New Audio
system.
3. The app will show a
list of suggested audio
systems to setup.
4. Your speaker will
normally appear in this
list as S1 or S2. It may
appear in the list below
called Other. Select the
speaker to be setup.
6. Choose whether it is
connected via WiFi or
Ethernet. If you wish
to connect using an
Ethernet cable please
(see page 40).
7. For a WiFi connection
the app will ask you to
choose a WiFi network
and enter the appropriate
password.
8. The Mode indicator on
your speaker will stop
fl ashing and remain lit
when it has successfully
connected to your
network.
Step 3 - Setup new audio system - Android device
If your device is an iPhone or iPad (i.e. uses iOS) please see page 10.
The UNDOK app has a setup wizard to help confi gure suitable audio devices to connect to your home WiFi network.
5. Once your device is
connected to the speaker
the Mode indicator
will fl ash white in short
bursts. Use the app to
complete the speaker
setup, including giving the
speaker a name (living
room, etc).
To Next Page
Loading...
