36
Information
Information
Factory reset
If you wish to completely reset your speaker to its initial state this may be
performed by following this procedure. By performing a factory reset, all
user entered settings will be erased.
1. Ensure your speaker is switched on.
2. To reset your speaker press and hold the Reset button for
approximately 10 seconds until the Mode indicator shows red.
3. The speaker should then clear its stored settings and restart. After a
further 10 seconds the Mode indicator will fl ash slowly (white).
4. You may then reconnect your speaker to your network using the
UNDOK app (see page 8 to 11).
5. Alternatively you can reset your speaker from the 'Settings' menu in
the UNDOK app.
In case of malfunction for any reason, reset the product as described above to resume normal operation. It
may be necessary in some cases to disconnect the mains power, then reconnect power after 10 seconds.
In case of malfunction due to electrical fast transient (burst), reset the product as above (reconnection of the
power source may be required) to resume normal operation.
When connecting the speaker to a router with an Ethernet cable, shielded cable is highly recommended. The
communication could be interrupted temporarily or noise may occur if using un-shielded cable and under strong
local interference. Normal communication will resume automatically when the interference signal is removed.
Mode indicator (red)
Reset
2
Mode indicator (white slow fl ash)
To Next Page
Loading...
