Roberts Stream 67 - Page 17

16
Conguration.
Connectingtoyourcomputernetwork-cont.
If you have followed the steps on the preceding pages successfully, your audio system will have connected
to your router, and then made a connection to the Internet and set its clock. You can then listen to radio
stations via the internet and use the other features of your audio system (see page 22 onwards).
Changingthenetworkconnection
In the sections above, you chose how your audio system would be connected to your network, either using
a WiFi connection or using a wired Ethernet cable. From time to time, you may nd that you need to connect
to different computer networks. The Network Settings menu allows you to change your audio system’s
network settings, scan for an alternative wireless network, or to manually congure the network parameters.
The steps outlined below describe how you can do this - see also the section 'Network proles' on page 82.
If you have no need to do this, however, please skip to page 22.
ConguringtheaudiosystemtouseanalternativeWiFiconnection
1. From the Network Settings menu select 'Network wizard'. This will present you with details of any WiFi
networks that are found. Scroll down the list using Menu Down to the desired network name. Press
Select to select this network.
The audio system will then use its WiFi system to communicate with the network. Depending on the
settings for the new network you may need to enter an encryption key (see pages 14-15). By default
the audio system will then acquire an IP address and other network settings from the network's router
using DHCP (Dynamic Host Conguration Protocol).
ConguringtheaudiosystemtousethewiredEthernetconnection
2. Connect your audio system to your router using an Ethernet cable plugged into the RJ-45 socket at
the back of the unit. From the Network Settings menu select 'Network wizard'. This will display a list of
any WiFi networks that are found. Scroll down the list and select the '[Wired]' option.
The audio system will then use its Ethernet connection to communicate with the network. By default the
unit will then acquire an IP address and other network settings from the network's router using DHCP
(Dynamic Host Conguration Protocol).
Last listened
Station list
System settings
Main menu
Internet radio
Backlight
Equaliser
Streaming audio quality
Network
Time/Date
Inactive Standby
System settings
Network wizard
PBC Wlan setup
View settings
Wlan region
Manual settings
NetRemote PIN Setup
Network settings
Network settings
Network wizard
Scanning...
Jones family
[WPS] Paul’s network
Smith
Brown
[Rescan]
[Wired]
SSID
DAB
30