Roberts Stream 67 - Page 18

17
Connection type
Wired
Wireless
IP settings
IP address
192 . 168 . 1 . 25
Subnet mask
255 . 255 . 255 . 0
SSID:
mynetwork
Network settings
Please wait
Connecting...
0 1 2 3 4 5 6
7 8 9 . _ - @
,
a b c d e
f g h i j k l
m n o p
q r s
Network wizard
PBC Wlan setup
View settings
Wlan region
Manual settings
NetRemote PIN Setup
Network settings
Manualnetworkconguration
If you do not wish to use DHCP for automatic network conguration, or if your network is congured with a
hidden SSID, then you will need to enter some network settings manually. The typical user will not need to
use manual network conguration. The facility is provided to allow the product to be used with networks where
the conguration of devices is not managed by the router, or where customised settings may be required. In
such cases it is assumed that the user already has sufcient knowledge to understand the terms and settings
used for this purpose. IPv4 address schemes are used.
1. From the audio system's Network Settings menu, select 'Manual settings'. You must then choose whether
to connect using 'Wired' or 'Wireless' connections. If you choose 'Wireless' there are as many as nine
settings screens, shown by the '1 of 9' progress marker in the top right corner of the display. If you choose
'Wired' there are ve screens and the progress marker will reect this, although the steps to set up the
network parameters are basically the same.
2. The subsequent menus allow conguration of the following parameters:
DHCP - On or Off
IP address - e.g. 192.168.1.25
Subnet mask - e.g. 255.255.255.0
Gateway adress - e.g. 192.168.1.1
DNS address (primary and secondary addresses)
SSID - needed for WiFi connections if the SSID is not broadcast
WEP / WPA / WPA2 key and settings
When entering numbers, the SSID or the WiFi pass key, the three controls on the right-hand side of the
screen have special functions. You can quickly access these by pressing the Info button and then use the
Menu Up or Down and Select as needed:
select '
' to erase a character just entered (long press to clear); Info again to continue
select '
' when the complete encryption key has been entered
select '
' to cancel and go back to the TKIP / AES options screen
3. Upon completion of the settings the audio system should connect to the network. If the connection is made
successfully, the audio system will return to the Network Settings menu. If the unit cannot connect, then
it will display a 'Failed to connect' message. You will then need to identify which setting may need to be
changed, or whether some other network issue is responsible. Once connected, the network settings are
saved. They are retained in memory while the audio system is disconnected from the mains.
DAB
30