gf12
12
Manual Robin SlimLine ENG - v. 1.0.0
4 System installation
4.1 Requirements prior to installation
Network connection with PoE (Power over Ethernet) is used to power the Robin; the power
supply must be 802.3af compatible.
PC with web browser.
The following web browsers are supported:
- FireFox
- Safari
- Google Chrome
4.2 Power-on the Robin
Connect the Ethernet cable connected to the Robin to a network switch with Power over Ethernet or
use a midspan and a standard network switch. The Robin will boot automatically (this can take up
to 30 seconds).
! Note: The length of the Ethernet cable may not exceed 100 metres. This is a limit of the Ethernet
standard. !
We assume here that the network supports DHCP; if so, all settings such as the IP addresses,
netmask, gateway and DNS are automatically populated.
DHCP is a default setting of the Robin. If the network does not offer DHCP, the network details must
be set manually.
S
System Installation
To Next Page
Loading...